Applies To:

Item: VPLAT0013ABP Matches: LR4

We have now specially-developed this trailer wires package for LR4 cars. This package seamlessly converts your own Rover wires plug to either a typical ‘Flat 4’ us specification connect or 7-way plug (both connectors incorporated!). Our very own high quality use sets were reliable and cost a fraction of the genuine models. They function a rubber plug cover to protect the outside trailer plug from factors and easy plug-and-go construction ways they can be set up in minutes.

Areas incorporated KitVPLAT0013ABP:

• 4 ea. M5 x 0.8mm x 40mm machine screws
• 1 ea. YMZ500770ABP utilize with truck connectors
• 1 ea. YMZ500502ABP utilize with car connections
• 5 wire links
• Training

Hardware Necessary For KitVPLAT0013ABP:

• Phillips Head Screwdriver
• 10 mm wrench

Installation Process:

1. Remove the remaining taillight assembly by removing the 2 screws. The tail light will display. (See photo1)

2. eliminate the Trailer Connector Access screen. (See photo2)

3. The VPLAT0013ABP Wiring use is available in 2 components. One spend the the fittings that connect inside truck, plus the next spend the fittings that connect in to the automobile.

4. make part with the trailer connectors and feed the funnel through orifice inside the bumper (the hole throughout the remaining). Maneuver the trailer connector through beginning. (it woosa coupon could take some turning and changing, nonetheless it will match.)

5. protected the connector aided by the 4 screws provided. (See pic 3.)

6. Remove the accessibility section into the remaining backside for the freight section of the car and discover the two grey connections toward the top of the open room and circular black colored grommet toward the base. (discover image 4 and image 4a.)

7. The grey fittings are held set up by 2 “dummy” connections. Draw both of the connections off their mounting brackets and take off the “dummy” fittings. Remove the plastic grommet also. (read pic 5.)

8. see the second rubberized grommet behind the tail light assembly and remove they. (discover pic 6.)

9. supply the wires utilize making use of automobile fittings through 2 gaps from inside the vehicle, ensuring the grey fittings that can plug to the vehicles tend to be experiencing toward the interior. (See image 7.)

10. the moment the cable tv is perhaps all the way in which through both of the openings into the automobile, push the grommets into location.

11. Plug the 2 grey connectors associated with the trailer wiring funnel in to the gray plugs of the car funnel and snap into put on the brackets.

12. Remove the nut from grounding stud (10mm) and secure the ring lug from the trailer wires use to this stud. Safe the use into car utilizing the fir-tree cable tie on the use.

13. get rid of the free tire, you has room to run the wire within the vehicle.

14. manage the cable tv along side opening under the automobile straight behind the bumper and maneuver the end using the connector so that it comes out into the opening in which you got rid of the tail light installation. (discover pic 8.)

15. as soon as you can see the connectors in your neighborhood behind the end light (discover pic 9), hook up them to the harness which you given from inside the vehicle. (See image 10.)

16. Make sure that the connections are entirely seated (you should listen easy once the connectors is completely engaged). Force the white synthetic securing tabs toward protected the connectors. (See picture 11.)

17. place these fittings together with the foam supplied so they will not rattle about in your neighborhood below the tail light set up.

18. Secure the truck connector utilize in car making use of the fir-tree wire link as observed in image 12.

19. Test the installation.

20. Reinstall the spare tire, tail light set up, truck access panel plus the access screen for the remaining rear of this freight section of the vehicle.